- Views 0
- Likes 0
FreqBox Demo with Steve Dunnington
MF-107 FreqBox 效果器是Moog 模組合成器的後代. 利用外部聲音輸入, 影響內建震盪器, 產生聲音變化. MF-107 改變音色的方法有下列幾種:
震盪器可強制和輸入信號同步.
震盪器可和輸入信號頻率調變(FM).
震盪器頻率可由Envelop follower 轉換輸入信號動態變化控制.
震盪器音量可由輸入信號強度控制
所有控制參數都可用 CV 控制. 可用表情踏板, MIDI-CV 轉換器或其它 CV 輸出合成器/效果器演奏你的 MF-107. MF-107 提供 CV 輸出可以控制 Minimoog Voyger, Little Phatty, Minitaur, 其它Moogerfoogers 或者其它類比樂器。
限量白色
The MF-107 Freq Box contains an analog VCO with continuously variable waveform which can be modulated by the audio input signal. Modulation of the VCO includes: hard sync, Frequency Modulation, and modulation of the VCO frequency by an envelope follower. The amplitude of the VCO is controlled by the amplitude of the input signal.
Front Panel Controls:
Frequency: sets the frequency of the VCO.
Wave: Morphs the VCO waveform from Triangle to Sawtooth to Square to skinny pulse.
Sync On/Off: Enables/ Disables Hard sync of the VCO by the audio input signal.
Env. Amount: Sets the amount of modulation of the VCO frequency by the Envelope
Follower.
FM Amount: Sets the amount of frequency modulation of the VCO by the audio input signal.
Mix: Sets the blend of input signal and VCO signal
Drive: Sets the input sensitivity and gain of the effect when active. Half to full drive amount adds overdrive.
Output level: Sets the output level of the effect when active.
Bypass Switch: Bypass LED is red when effect is off, and green when effect is on. The MF-107 uses a high quality buffered bypass ‘ when in bypass, the input is disconnected from the effects’ electronics.
I/O
Input and output connections are on " jacks.
Audio Input: accepts instrument level to line level inputs.
Freq: Accepts EP-1 expression pedal, or -5 to +5V Control Voltage to set the frequency of the VCO. Input voltage is added to position of the front panel Frequency control.
Wave: Accepts EP-1 expression pedal, or -5 to +5V Control Voltage to set the waveform of the VCO. Input voltage is added to position of the front panel Wave control.
Env. Amt: Accepts EP-1 expression pedal, or 0 to +5V Control Voltage to set the amount of envelope follower modulation of the VCO frequency. Input voltage is added to position of the front panel Env. Amount control.
FM Amt: Accepts EP-1 expression pedal, or 0 to +5V Control Voltage to set the amount of frequency modulation of the VCO by the audio input. Input voltage is added to position of the front panel FM Amount control.
Mix: Accepts EP-1 expression pedal, or 0 to +5V Control Voltage to set the waveform of the VCO. Input voltage is added to position of the front panel Mix control.
Audio Out: Supplies the output signal.
Env Out: Outputs the unconditioned Envelope Follower Control Voltage signal.
Osc Out: Outputs the wave-shaped VCO signal as a +/-2.5V Control Voltage signal.